I can't seem to get my burner to work. I am using Adaptec EZCD Creator 4.0 and I get the following message at the end of the process:

T0100: I/O error (03/73/03) - CD error - power calibration area error
T7728: TrackWriter warning - Operation continues

I have gone through the user guide on this forum but with no change to my outputs (coasters).

Any help woudl be appreciated.

ajk

bump

Try using nero and make sure you´ve got installed the aspi drivers and dma is enable

I think Easy CD Creator 4 is too old and your CD-RW drive is new and the software can't recognize the drive. Try Easy 5.03 (the newest) and all will be good. The another suggestion is a different burning program (Nero especially).

Agreed. I also have the Samsung in question. I use E CD C 5 and it works great. Don't expect to get a good burn on some of those copy protected games though. I have yet to get it to work. Copy CD is much better for that.

I had a SM 304B Samsung burner and changed the firmware to BS05 ( Avaliable from Samsungs home page) to enable Subchannel reading with Clone.It also worked fine with Cdrwin and Nero and i used it to back up thousands of discs.I only changed the writer because i wanted a faster writer.
As for Easy Creator total junk and only useful for audio.