 |
View Full Version : Refresh Rate set to high....... [; ; winNT4]
|
detroit Jun 10, 2002, 08:23 AM I have a computer that had its refresh rate set to 120hertz way over what the monitor can handle. Now dont get any picture... Is there any way of getting this back? I tried last know good but no luck... Thanks Detroit................... SonicBoom Jun 10, 2002, 08:47 AM What monitor do you have? SonicBoom detroit Jun 10, 2002, 09:45 AM Sampo gl 19" wolfy Jun 10, 2002, 09:57 AM Have you tried starting in safe mode? I believe you can adjust the refesh rate from there. gooner Jun 10, 2002, 10:08 AM Wolfy is right, when it starts up you should be able to put it into VGA mode being NT4 gooner Jun 10, 2002, 10:10 AM Bring it down to about 80-90hz, that should be enough detroit Jun 10, 2002, 10:11 AM I tried starting in vga mode and running last know good..... Still nothing. What I guess I will do is run through the login blind and change the settings with keyboard. gooner Jun 10, 2002, 10:17 AM Don't run last kown good, put it in VGA mode and go straight in to the desktop change it there and reboot detroit Jun 10, 2002, 10:18 AM Putting it into vga mode dont work. gooner Jun 10, 2002, 10:29 AM I suppose you can try going in blind then, I cannot think of any other way around it........Sorry detroit Jun 10, 2002, 10:45 AM Got it going blind method.. littlejack Jun 10, 2002, 02:42 PM i did this the other day i was seeing how high i could get the refresh rate - amazing wot u get up to when were bored at work :) luckily mine worked with the vga mode good to see you sorted it |