i went to radio shack to pick up a solder iron for when my chip comes in and wouldnt you know, my girl spots some kynar wire. it took me 4 radio shacks to finally find some. anyway, my question is how small is the wire supposed to be. its 30awg but it looks extremely thin compared to some wires i could have sworn i saw. its been a while so i could be mistaken. any input is appreciated.

I used the same wire. It'll work fine.

yes its a very good wire but u got to watch out as it breaks very easy
infact to easy
so if u start bending the wire to much your break it inside
just be carefull when using it guys


backup2k1(the name u can trust)

thanx for the tip cuz i tend to bend it in the soldering process but i'll be careful now

what is the thickest that you think would be safe to use????????

30 is max, my 2 cents.
use 22