I've got a Neo 2.2 chip and I use RegionX to boot my CDR games up. How do I boot my DVDR games with AR2 V2?

well you could check it out at CousinFizz's site http://cousinfizz.4mg.com/ but here i got it from it for ya:

1. Place your GS2 v2 disc into the PS2 & press reset.
2. Select GameShark Codes, then press X.
3. Select Add New Game, then press X.
4. Press X a further 3 times. Each time, Updating Code List, Please Wait will be displayed.
5. Hold the reset button until it turns red.
This needs only be done once. Your PS2 is now ready to boot DVDRs by only needing to do the following:
1. Place your GS2 v2 disc into the PS2, then hold the reset button until it turns red.
2. Ask someone to press the reset button & keep it held in, until told to release it. After a few moments, the reset button will turn green & the GameShark main menu screen will be displayed.
3. Highlight the GameShark Codes, but do not press X yet.
4. Press eject & swap the GameShark disc for a demo disc that has a large size TOC.
5. Press eject once more to close the drawer, then wait 10 seconds.
6. Press X, then highlight New Games & press X once more.
7. New Code should already be highlighted, with either an empty box to it's left, or one with a tick in it.
8. Press X to add or remove the tick (it doesn't matter which), then press Start on your controller.
9. The screen should now say With Code/Without Code. Highlight With Code.
10. Ask the person helping you to let go of the reset button, whilst at the exact same time you begin pressing X continuously until the screen Updating Code List is displayed.
11. The drawer will open & you will have a short time to replace the demo disc with the DVDR, before the tray closes itself.
12. The screen will then go black for a while, & the game will load.

Try the 'search this forum' box & put in a key word for the search, you'll have your answer.
Key words are more than three letters, e.g. 'manual,' 'version', 'name of a game,' 'nero', 'backup' 'AR2.1"
" messiah", "region" Etc.


Vyse, do you think the search box & faqs are invisible?

handy it wasnt me who asked the question.