i try to install the enigma chip on my xbox now my xbox doesnt have picture and it wont eject . can someone help me

Moving to Xbox modchip help forum.

http://www.cdrom-guide.com/forums/imgs/jams.gif

It pretty much means that the system cant read the bios so one of your wires is crossed or there was a bad solder link or you may have bridged some solder, I would go over each connection you made to make sure there all in the rite order and also check each for bridges and make sure the wire is secure. If any wires are crossed, be very carefull when you try to remove any wires or solder, Ive read about alot of people wripping up tracks and messing up there xboxs when they try to remove the wires they soldered, so take your time and be patient and dont try to force anything. good luck L8R

try using some solder brade very handy for removing solder bridges.

pretty sure you bridged it. It's very easy to bridge the tracks since they are so close to the solder points. Are you using flux? If not, get it. It's a life saver.

chindavon@hotmail.com

well my xbox doesnt work yet got a ps2 premodd from lik sang cant get that to work either not been my week . thanks for all your help

chindavon21 just askin my XBOX was fine i was playing Bruce lee on it but it froze and when i went to open the drive by pressing the eject button it started flashing green and red. anything i can do?

please some one help!!!!

Soner