After i have burnt my dvdr film always jumps towards the end of the film
have used bukpaq and datasafe classic dvdr at 1x speed still the same playing them on 3 dvd players still jumps anyone any ideas

jamie

jamiebarr@lineone.net

what software you using to burn mate, try prassi if you have not done with that. Otherwise its media compatability. what gen of bulk baq?

evade

try defraging the drive that the film is on several times or until it wont defrag anymore.

I doubt it's the media as I have come across this allot, to sort this out I make a title set and burn with PrimoDVD 2.0 as a data disk, seems to sort the problem out.

thanks for all ur replys ,i have sorted it out iam using prassi did not reliase
recording speed was set at max!!!.set it to 1x and het presto one working
dvdr of grease

cheers for all ur replys

jamie

ok this may or may not help you out!

on a fully defraged 80gb hdd

FWS X2 media recorded 4.35gb title set* @ X 2 with PrimoDVD 2.0

burn 1;
I left the pc alone whilst the burn took place, playback was flawless in both my Pacific 1000 and Pioneer 717

burn 2;
same as above BUT I started multitasking (surfing/email/printing/listened to some mp3's nothing too excessive) .... the result playback on my Pacific 1000 stopped playback at the last chapter, froze up my player and then reset it, Playback on the Pioneer 717 slightly skippy (noticeable) but the disc played through to the end.

I left Primo open and just inserted a new dvdr to burn to

burn 3;
back to same process as burn 1, result was as burn 1 a flawless copy.

I think that some discs are just picky as to how well the data is burned to them whilst multi tasking, so if in doubt just leave your pc alone whilst it's burning!

*title set was created with Spruce with a chapter point every 10 mins