I've downloaded latest version of CloneCD but for some reasons cannot make it work. It takes many hours to read 1% of normal data cd:hdspin: I tried copying some protected games with fast error skip and same problem. Is this normal? can anybody help??:hdspin: :hdspin:

Does your drive support Fast Error Skip??

Check here (http://www.elby.org/CloneCD/english/cdr_a.htm).

Fast Error Skip can literally take hours. Can you burn discs normally without Fast Error Skip turned on??

Try to copy a unprotected CD (such as Win98SE or WInXP CD's) and see how that goes. That will give us something to start from.

-Zack

http://www.mindshatter.com/zack/smanback1.gif

After re-reading you post, it appears you have had the same trouble without Fast Error Skip on/

That being the case, are you able to succefully burn with another prgram such as Nero?? Have you checked your ASPI layer?

Go to this page here (http://www.cdrom-guide.com/forums/showthread.php?s=&threadid=6827) and go down to the ASPI section and read up on it there. Please post any more details about your problem, configuration, etc.

Hope this helps.

-Zack

Thanks Zack, I'm using creative 8432x (actually it is 8438x) and had no problem with nero. copying some protected cds with blind read was also ok.
I tried clonecd -as you suggested - with out the fast error and unprotected cd and it went smooth. But again failed to read "Black&White" (w/o fast error skip). my PC (1.4 Mhz, 128 ram, 40G harddisc ,ASPI no idea!!)
Regards
Adamss