Has ANYONE figured out how to remove the labels over the screws on the bottom & still keep them intact so they ca be re applied?

Any ideas would be appreciated.

hi the easy way to get the labels of under the xbox is just by using
a hot air dryer on low heat for 20 seconds then put it onto hot air
and all u do is say use a pin go to the side of the label and very slowly
lift the label up and u got yourself a intact xbox label
then later on you can just stick it back down

hope that helps you out a bit


backup2k1(the name u can trust)


ps

not sure if u want to try this but when the psx2 had labels
all they used was a bit of lighter fluid and it came off no problem