Just bought a 9000mb (99mins) cd-r but when i try to use it with nero it only recognise's it as a 80mb cd-r, is there anyway of sorting this out .




can anyone out there help me :confused:

Never seen a 90/99min CDR that had anything other than 80mins in it's ATIP..

Make sure that overburn is enabled and set to 99mins, also that you are burning in DAO. Then just overburn.

sounds like a whole new language to me ATIP???

where do you enable the over burn on nero Celtic, im small time when it comes to burning

ATIP = Absolute Time In Pregroove. It's where it says how long a CDR is, along with other usefull info.

just tried it worked a treat on a normal 80 min cdr how far can you sent the overburn are is there no limits

"Absolute Time In Pregroove"...sounds like foreplay! lol

Some 80min CDR's can be overburnt by a couple of minutes, others not much at all.

90min CDR's can definatly be overburnt to 90mins, some around 94. Basically it depends on each disc. You can use Nero CD Speed to test.

thanks

Can I just add that it also depends on the overburning capabilities of your burner. I have had quite a few problems with Nero, even with overburn enabled and the settigns set up so that the overburn mentioned above should have been possible, but nero says theres not enough room on the cd. Using cd-mate I can overburn easily and have no problems.

I would suggest that if you are having problems then try some different software.

None of the 90 min discs ive tried show up as 90 min discs, only 80, Celtic is right.