I am new here, but I have a problem. My burner, I know will not read or write gd+g. I have a lot of cd+g discs, and would like to copy them. Could someone tell me if I can do this with my non compatable burner, and how I would go about doing it? Thanks
P.S. My burner is a Mitsumi CRX5TE if that matters.

Hi there,

For all the help info you need, go to www.karaokeplayground.co.uk and read up on the "Using an incompatible burner" pages. Or, if you want a Plextor 16/10/40A Writer, that is a dream tool for this job, email me back, and I'll tell you how to get one.

Alan

karaokeplayground has been down for a couple of days now

I believe that you should be able to make a 1:1 copy with clone cd,alcohol,diskjuggler or blindwrite. How old is your drive?, if its a very new model then support may not yet of been added.

Thanks for the info. Karaokeplayground is still down, but I will check it out. Also my burner is about 3 years old, and I have tried cdclone and alcohol, and it didn't work......no graphics.

your better off with a plextor off alan traffo7 (if hes got any left) or steve 54 ....believe me ive got one and they do anything.

I have found out some more info on your drive and it doesn't support disc at once raw +96. I though it was a new model which would of supported this required writing mode. Your drive cannot write cd+g.

I had this prob m8 so i used the latest clone softwear and had to sort the settings in clone then bobs your uncle if you need info on how i can mail you a guide LMK.

jordon106@hotmail.com

Hey all, scrap the old burner I had, my Dad gave me a new burner, it is a Philips CDRW3210S. It also does not do cd+g, but I tweeked the CloneCD settings and it works! I still need help though. It is an accasional coaster maker. About every 3rd disc I do it has an error message that says "SPINDLE SERVO FAILURE (4:0x09:0x03)". It doesn't have that error if I write at 16x or higher, but if I write above 8x the graphics are messed up. Help if you can.

i have a brand new yamaha CRWF1 burner and am having troubles getting it to give me a clean burn. it does the disc copy without a problem but when played in my karaoke machine the graphics are unreadable.. i have tried the cd's in different karaoke machines and even used different brand names of blank cd's. my friend has an older yamaha 8x4x24 burner and i am using the same speed settings for reading and writing, even tried to slow it down to 4x r/w but didn't help any.. could it be my version of cdrwin?

could be, but I don't think so, although it's been said many times before on this forum........don't use a version of cdrwin with a keygen. That said though, the errors you tend to get when using a keygen version are a little different than those you describe (mainly static or 'white noise') Try reading at a slightly faster speed, say 6x or 8x but keep your burn speed to 4x