Just wanted to give everyone a heads up what it took to finish.

Executer2 Lite Mod Chip, 8 very easy solder points, the DO point I...

Sharpened a 24 gauge wire with a dremel tool, then bent the tip slightly. (like a barb) then placed the wire along the bottom of the Mobo taped (the Alternate DO point) with electrical tape. Then carefully soldered the barbed/sharpened tip to the DO point. It was easier with this setup then I think with any other

Sony External DVD writer ($429), FujiFilm DVD +R Media, Record Now Max (New Primo DVD) software, ISOMaker 1.21 to create the iso's, burned the media at the slowest speed and set Options to CD Mode1 (Blocking 2048) - DVD

Thanks it folks, took a ton of time and some outstanding help from Alexoi and Jesterrace and the mother of Xbox modding sites, Xbox-Scene.com

I had no probs at all soldering to the Do. I just tinned the wire, and stuck it in the hole. After that i heated the wire, and barrel up, and it works fine.