Hello I have a question about Flashing X2p
When I begin flashing, the bar on the bottom
fills to 100% then when it tries to verify I get an
error "Verification Failed" any one know what the problem could be?

i think your jumper is still on for flash protection... i could be wrong though

i'd say ur right mate :tup:

I thought u leave the jumper on for the X2 pro.

is there even a jumper for the pro... maby your switch is on flash protection than... turn it off

how long is the cable you are using

cable... what cable? i think im missing suttin

My cable is 6ft, do they make them shorter than that?

i'm using a 6ft plus gender changer and it verifies fine for me
hmmm

Sometimes the verify bar gets to 2 or 3% then I get the
failed error.

make sure the cable is seated all the way. i had this problem one time and all i did was wiggle my cable.

Yeah I have the cable down and screwed in tight.
Does any one else have any ideas that may help?