 |
View Full Version : help need to open a folder in DOS
|
NETTY1723 May 03, 2003, 04:05 PM WINDOWS XP fat 32 c:\> need to open a folder called (firmware) on c drive in (dos) have'nt got a clue what to type,can anyone please help, beardedwonder May 03, 2003, 04:13 PM cd firmware cd= change directory if you want to get back to c:\ from that folder type cd.. HTH NETTY1723 May 03, 2003, 04:37 PM got this far c:\>FIRMWARE> but now need to (run upgrade.bat) and dont know how to do it helllllllllllllp beardedwonder May 03, 2003, 04:51 PM type upgrade NETTY1723 May 03, 2003, 04:55 PM just goes back to e drive m8 beardedwonder May 03, 2003, 05:48 PM i think that could be because its run. Are you sure there are no parameters that you need to run with it. BTW did you type upgrade after you had got into "C:\Firmware\" ? NETTY1723 May 03, 2003, 06:07 PM have mailed u thru profile the instructions i got m8,hope u dont mind,and thanks for your help so far, beardedwonder May 03, 2003, 06:18 PM ok, e-mails on the blink at the mo, stupid ISP :(. Anyway, go into BIOS, with DEL key when your computer first boots and shows all the drives. Go through the menus till you find the DMA mode and turn it off. then boot your PC with the disk in and select boot with CDROM support. When it's loaded type "C:" then "cd firmware". this will take you to the firmware folder. Then just type "upgrade" From what i read this should work. HTH |