Right built a pc up sounds like its booting up ok even though dont make beep it usually does nothing appears on scren but you can here it trying to access hardrive. Here is bits i used:

http://www.ebuyer.com/customer/products/index.html?action=c2hvd19wcm9kdWN0X292ZXJ2aWV3&product_uid=51254

Got amd 2.4ghz processor in and 521mb also got radeon 7000 graphics in anyone got any ideas?

If the pc sounds like its booting up and hard drives spin but nothing on screen, then maybe a faulty monitor or graphics card?

If cpu, ram or mobo are faulty, you usually get a long beep. Although I would have thought that if the gfx card were faulty it would do this too. I know it sounds stupid, but have you checked the monitor? Does it remain in standby mode?

Id also be a bit concerned about not hearing that familiar beep.... Can you give any more info? Has it ever worked, or is this a brand new build? Im not convinced that just cos the hdd's spin up, means any info is being fed to them.

Double everything is connected corretly. If nothing appears on screen it could be the monitor, gfx card or motherboard.

amd 2.4ghz? which cpu is that or did you clock it?

defo not screen as i am using screen on other pc, there is no beep and you can hear hardrive spin once drives dont try and load either think its a 2.4 or similar

i had same probs with a board from ebuyer.
powerd fans etc but thats as far as it went.

try the other parts in another pc if poss

btw it was the exact same board

just got it going happened abit randomly but i cant install windows i usually boot straight of cd and its done but it always takes me to dos. I am not very good in dos anyone got any advice cheers for your help :)

any idea how you got it to boot m8???
i am having exactly the same problem with that board!!!!
tried everything, but cant get a pic on the monitor

The same happend to me when i built a computer some how i put the cpu fan on and it dident completly cover the cpu and it burnt out. Try taking the cpu out and smelling it maybe look at the pins side and see if u can see any burnt bits in the middle. It might be that :/.

If your not getting any system beeps whatsoever it may be the power supply or even the motherboard itself that is faulty.

have you checked that the bios is not set to clear.
have you made sure the memory is seated right along with any cards and the cpu.

i had a similar prob a while ago with a pc chips board, it turned out to be the bios pins were set to clear on the m/b, look in your manual