I bout a Xecutor 2.3 Lite Plus from Modchipman.com.

I know its installed right because of the blue LEDs that light up when I turn on my Xbox. However, I think its a blank chip possibily because on bank 1 or 2, when I turn it on, nothing about Cromwell boots up. I just get the normal MS Dash.

Am I doing something wrong? Or should I request a exchange?

Actually, I'm not sure if its installed right.

It doesn't say Xecutor upon bootup. However the lights are blue on the chip! And I also made sure that the chip is enabled too.

it only says xecuter if you have an x2 bios already on there- which for legal reasons they can't- x2 and evox bioses are all hacked m$ bioses they can only provide legal bioses such as the cromwell bios

cromwell is 1mb, set it to the 1x 1mb config, and switch it on

its a lite which means you can select between bank0(512k) and bank1(512k) only
i would check that the lonely pogo pin is making proper contact with the D0 Point

as psibob said mate try your Do point i had same senario all lights on appeared to be working but was a bad Do connection

As nimbles said it is an illeagal bios that the executors contain when they are flashed to boot a game so think about it the chip may have been sent to you blank........Mine was when i bought my xecutor 2.2 which also has a pretty blue light on it But i was also given a bios disk to boot up on when i installed the chip.........the blue light only tells you when the chip is on or off ....If the lite is blue the chip may be on but if its a blank it wont boot nuffink.....:confused: :confused:

premiumg follow this tutorial
http://www.teamxecuter.com/biosimage.htm

just note note for the lite- 256 k bios's can't be used you'll need 512k bios's