I've got a v 1.6 motherboard and I want to install my xecuter lite 2.2 in it so I can put a dashboard back on the hd. The hd got messed up while it was softmoded and now I want to install the dashboard back but I can find where to solder the D0 wire or any of the wires. Thanks everyone!!

:tup:

try this link see if any help
http://pictures.xbox-scene.com/4/xecuter2.3/v16_rebuild_x23B.jpg
cheers
Doug

so do this mean I dont use the other colored wires or do I just add them along with the additon of the new wires for the other colors?

Thanks

this is not my motherboard, the points dont match.

this is not my motherboard, the points dont match.
well its not a 1.6 then, is it?
maybe you have a 1.6b?

It is a version 1.6 I've seen the pic but the guides on how to put the chip in is confussing as hell!!! I've got and lite 2.2 chip and I"m tired of putting these wires everywhere to get nothing. I just need to add the dashboard back so I can install slayers and go from there. I've tried making up the boot disk with no luck. Any suggestions?

Thanks