colin.scoble
Jan 16, 2002, 08:00 PM
not sure what i have done if anything to it.bought an external scsi got that to work ok. this may be a coincidance my easy cd creator5 plat never worked with my scsi plex cdrom.i thought use the scsi external as a rom and still use the liteon for recording.also meshed about with nero put on a demo and would only burn at 8x.is the liteon had it only 3months old.would upgradeing the firmware help,at the moment the green light flashes all the time no discsare recognised and the tray ejects goes back in again.before i get it dismantled would a software problem cause.any help.colin
Darkman
Jan 18, 2002, 12:57 AM
Check the burner in Device Manager to make sure it's properly installed and recognised. If there's a yellow exclamation mark next to the burner then there's a device conflict, right click on the burner select remove & then reboot the PC.
You may need to fix the ASPI layer, get ForceASPI from Cyrus Troy's site (http://www.cyrus.troy.btinternet.co.uk/downloads.htm).
Also try different media, it may just be a bad batch of discs.
NotAHacker
Jan 18, 2002, 10:57 AM
You have a well documented problem!!! To fix it shut down your pc unhook the power and the ide cable to your liteon, reboot the pc go it to windows then shut down and unplug pc re-install liteon. You should be good to go if not try again. I've gotten your problem a few times and that's what fix it for me every time. Good Luck.
To fix any of your Liteon problems try this. (http://www.cdrinfo.com/forum/)
:hdspin::round::hdspin:
