View Single Post
  #3  
Old Jul 23, 2002, 12:57 PM
jspr57 jspr57 is offline
Veteran
 
Join Date: Mar 2001
Location: London, England.
Posts: 1,149
Default

Issue: Invalid / Non System Disk error.

Cause: This error can be caused by one or more of the following possibilities:

Floppy or CD that is not bootable is currently in the computer.
Hard disk drive does not have bootable files on it.
CMOS is not setup properly.
The hard disk drive is bad or not connected properly.

Solution:

Floppy or CD that is not bootable is currently in the computer: Verify that no floppy diskette or CD is currently in the computer. If a diskette or CD is in the computer that is not bootable your computer may attempt to boot from that diskette or CD causing this error message.

Hard disk drive does not have bootable files on it: It is possible that command.com or another bootable file may be missing from the hard disk drive. Follow the below steps to possible resolve your issue.

Boot from a bootable floppy diskette. At the A:\> type fdisk <press enter>
If you receive a message no fixed disk present read Hard Disk drive is bad or not connected properly. If you are able to get into fdisk, choose option 4 to display the partition information. In the partition information, if the System is listed as FAT16 or FAT32 then continue to step 5. If you have a message indicating no partitions defined, no information is on your hard disk drive and you will need to create a new partition. See our fdisk page for additional information.

If you see FAT16 or FAT32 in fdisk press the ESC key until back at the A:\>
Once at the A:\> type, sys c: <press enter> (only do this command if you are using the same operating system that this diskette was created on).
This should return a message 'System Transferred', if you receive bad command or file name and have verified you have type the command properly you will need to obtain a bootable diskette with the file sys.com on it. If system was transferred successfully, reboot the computer and issue should be resolved.

CMOS is not setup properly: Verify that your hard disk drive is setup properly in CMOS and if CMOS has bootable options verify that the hard disk drive is listed in the bootable options.

The hard disk drive is bad or not connected properly: If you have attempted all above suggestions and you are still encountering the same issues. Verify the connections are properly connected to the computer if the hard drive was recently installed or the computer was moved. Unfortunately if all connections are setup properly and all the above recommendations have been attempted it is likely that the hard disk drive is bad.

Regards

Last edited by jspr57; Jul 23, 2002 at 01:01 PM.