View Single Post
  #2  
Old Jun 12, 2005, 12:09 PM
9Homersimpson9 9Homersimpson9 is offline
Senior Member
 
Join Date: Dec 2003
Posts: 242
Default

Gettinh the PS2 set-up page after the install means you were crushing a wire on the modchip inside the PS2, sounds like you may have blew the board or a few fuses...

Try sc****** in between each leg on the bios chip, were you would have soldered a few wires too, use a pin to do it, you may have bridged one of the legs that is so small that your eyes cant see it!

Let us know how you get on...

9HomerSimpson9
Reply With Quote