Cannot create C: drive [Toshiba; 100CS; dos]

[hiboy]

sponsored links
{postbit1_5-Ad}
 
well good luck and let us know how you get on

[meek_imp]

OK.......i redid a format after using destructive pattern testing, and went into FDisk and created a primary DOS partition. However this time , the maximum partition size has been reduced from 773 Meg to 504 Meg ???

Anyway, i created a partition of size 500 Meg, set it as active and restarted my system. At the A:\> prompt i typed c: and it recognised the c: drive !!!

However, when i tried to format (format c: /s)....it now says "Invalid media type reading drive C - Abort, Retry, Fail?"

Any command relating to the C: drive , be it dir, scandisk, label etc....all give this message.

Any ideas???

Thanks

[hiboy]

did you try to do just a format and not just format c: /s
if not just type format c:
sorry for the late reply been at work

[MasterMind]

Meek, have you redetected your HDD is BIOS ? Possibly LBA mode is disabled in CMOS that is why it's showing 504 MB HDD in FDISK.

Give "FORMAT C: /S" command from A: only and not from C: